Brekkie Roll - Limerick

[kvinyl]

what time will are you leaving Galway Pete, meet you at the Topaz in Kilcolgan?

 

[kvinyl]

You still not fix your wipers? Lazy git!!!

no in fairness, I'm getting handy enough at dodging the rain drops when I get caught in a shower...

.

 

[kombi.noise]

what dyou think?
8.30 or 8.45am

 

[kvinyl]

8.45 probably alright? Brendan is joining us on the way down but even allowing for stopping off in Bunratty we should get down in 60 mins...probably hexed it now...

 

[BRENDANGOBRIEN]

8.45 probably alright? Brendan is joining us on the way down but even allowing for stopping off in Bunratty we should get down in 60 mins...probably hexed it now...

Don't think we would be in Limerick by 10, if ye are meeting up in Kilcolgan at 8.45.

 

[69bug]

Coxy, will this be cancelled due to salted roads ? (Not that I care, coz I'm walking)

 

[kvinyl]

Don't think we would be in Limerick by 10, if ye are meeting up in Kilcolgan at 8.45.

Go for 8.30 so at Kilcolgan? What time will you be in Bunratty Brendan?

 

[Coxy]

Coxy, will this be cancelled due to salted roads ? (Not that I care, coz I'm walking)

I'll come back to you on that Liam. It's taking more time than I thought to check them all out

 

[BRENDANGOBRIEN]

Go for 8.30 so at Kilcolgan? What time will you be in Bunratty Brendan?

How about around 9.15, should be there in plenty of time then.

 

[kvinyl]

How about around 9.15, should be there in plenty of time then.

Grand, see you there Brendan - 8.30am I guess Pete?

 

[kombi.noise]

will b ready to roll at 8.30 so.
i think gus the bus will b joinin us too.

 

[knk]

Damn Beetle...went out today to bleed the brakes for tomorrow and a couple of hours later I still haven't touched the brakes and there is half an engine spread across the floor!!!

Gonna be a late one tonight!

Bug or Bus...I'll be at the Dublin Meeting point in the morning.

 

[tonyvw]

are non members ok to come along ???

 

[Rez]

Of course Tony. I'd say there should be a load of non members tomorrow.

 

[Roadcow]

Nice advertizing job Coxy! I hope that everyone has a blast. Wish I were there actually.

 

[duts]

What a lift Kev?

 

[Rez]

Not giving up yet buddy. Just got my second wind (gotta lay off them beans).
Heading back out there in a few mins. If I have to pull an all nighter so be it.

 

[duts]

Best of luck, as a matter of interest are the splines on the shaft the same? oh and make sure the angle of the engine is the same as the box.

 

[Rez]

Best of luck, as a matter of interest are the splines on the shaft the same?

Yea. My issue was that it wouldn't go on properly. After counting them (24) and after some consultation with Donal Dollery and John Knightley it turns out that the splines needed a good clean. Even Podsy was on the other end of a phone seeing how I was doing.

oh and make sure the angle of the engine is the same as the box.

cheeky fucker! :looool:

 

[duts]

Yea. My issue was that it wouldn't go on properly. After counting them (24) and after some consultation with Donal Dollery and John Knightley it turns out that the splines needed a good clean.

cheeky fucker! :looool:

wasn't trying to be cheeky, it happened me the last time i was tryin to put the engine back in the beetle.