[Wanted: Parts] Hub cap clips
- Thread starter mcfanta
- Start date
See as you have seen on my thread. Im having rubbing problems so I tried the original steelies nd iv acres of room. But iv a set of alloys laying around not much wider than the steelies nd I reckon they would work. The empi's are just too wide.
http://s1015.photobucket.com/user/m...53730841533_2027204252_n_zpsbd963d3d.jpg.html
http://s1015.photobucket.com/user/m...53730841533_2027204252_n_zpsbd963d3d.jpg.html
ah right.
about the EMPI 8's, it's not that they're particularly wide, it's just that they have a stupid offset of 23 or so. Combined with the extra 12mm ish of "push" the drop spindles give you and you effectively have an ET10 wheel when compared to the bog standard original setup. You can get extra-camber eccentric adjusters from the likes of machine7 to allow you to tuck the tops of the wheels in a bit better. Plus you'll get eleventy million extra scene points from the watercooled boys for having rad camber, yo.
about the EMPI 8's, it's not that they're particularly wide, it's just that they have a stupid offset of 23 or so. Combined with the extra 12mm ish of "push" the drop spindles give you and you effectively have an ET10 wheel when compared to the bog standard original setup. You can get extra-camber eccentric adjusters from the likes of machine7 to allow you to tuck the tops of the wheels in a bit better. Plus you'll get eleventy million extra scene points from the watercooled boys for having rad camber, yo.
I ordered 4 sets the last night. Cheers mate
Im also looking for a good set of steelies if there are any around
I hate sounding petty... but McFanta.... GET YOUR OWN AVATAR AND STOP USING MY MARTAHON..........!
Thanks, in advance.....!!!
Thanks, in advance.....!!!