[Wanted: Parts] T25 front lowering springs

[podsyb]

Looking for 2 front lowering springs for a T25 if anyone has a pair , 50 - 70 mm drop

 

[walshe]

angle grinder????

 

[podsyb]

still looking for a set of lowering springs , have managed to keep the grinder at bay so far

 

[rascal1]

still looking for a set of lowering springs , have managed to keep the grinder at bay so far

Just get the oxy/acetylene bottles and heat the top coil and watch as the weight of the van bends the spring and stop when it is low enough. Just another stupid way of doing it..]

 

[podsyb]

Just get the oxy/acetylene bottles and heat the top coil and watch as the weight of the van bends the spring and stop when it is low enough. Just another stupid way of doing it..]

has been mentioned by Mr Dollery too , think I may be sorted now though , thanks for the suggestion. might use it yet

 

[CulmoreDubClub]

This sounds good,...lol...sounds better than the cutting option as now the spring has still retained its correct mounting surfaces at each end...

 

[brianm]

I know neither are 'ideal' but I thought cutting was seeing as the preferred option as long as spring allows it, due to softening the steel.
http://www.eatonsprings.com/cuttingcoilsprings.html